Unique among fireproofing coatings, as it is a hybrid material with
8 different ceramics and intumiscent additives.
Humidity and
water-resistant.
Does
not flake off like many conventional fireproofing materials.
Constant adhesion above 2000ºF, stays intact.
Mould and mildew
resistant.
Fights condensation on its surface.
Uses
Tested for use directly on structural steel to give a one or two
hour fire rating, depending on thickness applied.
Application
Although
SP2001F Fire Coating can be
applied by non-professionals, SC2 Trading recommends using a
certified applicator. To get more information, please contact us at
info@sc2trading.com
Preparation
Surface must be clean and completely dry, with no loose debris or
particles, rust, dirt, oil, films or residues of any kind. SP2001F
Fire Coating will cover previous coatings if they are fully adhered
to the surface.
Mechanically stir, as ceramics will tend to settle.
Application methods
Airless sprayed: tip size 1.65mm; build to desired thickness.
Brush if necessary
Applied
rate:
1
hour fire rating - 0.12m2/liter
2 hour fire rating - 0.073m2/liter
Film
thickness:
1
hour fire rating - Wet: 7.62mm Dry: 6.35mm
2 hour fire rating - Wet: 12.7mm Dry: 10.16mm
Dry times:
8
hour to touch.
12 hours to overcoat.
Full cure:
21 days.
Limitations
Not suitable for underwater use
of any kind.
Do not use as floor coating.
Do not used directly on food
preparation surfaces.
Not to be used as an insulating
material.
SP2001F Fire Coating is grey in
colour and rough in texture.
