RustGrip® is a metallic-based,
moisture-cure polyurethane encapsulating coating that will coat over most
surfaces to seal them up against further corrosion, weathering, and physical
wear. RustGrip® is a three-coats-in-one system that acts as a primer,
intermediate, and topcoat in one.
Excellent for minimally prepared surfaces, ie. No sandblasting
Protects steel, aluminum, concrete, wood, fibreglass, lead-based
paints, polyurethane foam, and other coatings.
Extremely tough, it makes an excellent floor coating.
Submergible in 100% nitric acid without any effects. Designed to
withstand acids, salts and caustics with no loss of strength.
as a Class A fire coating. In case of fire, Rust Grip® will help to
prevent spread of, and will not contribute to, the burn.
Certified by the EPA for encapsulation of lead-based paints and
Prevents mold and mildew from forming.
approved for use in and around food preparation areas.
year lifespan on roofing under normal conditions.
In its design, RustGrip® will apply
over a surface and immediately find the pores of the surface and immediately
fill them. Within an hour of application, it will begin its cure cycle. During
this cure cycle, it will pull moisture from the air and begin to microscopically
swell within the individual pores as it hardens. This process anchors the
coating and seals against any possibility of air, moisture, or any minerals
attacking the surface causing any further corrosion of any kind.
Corrosion and weathering protection. RustGrip® is UV-controlled and
is not affected by hostile environments.
Overcoat rusted areas to stop and control corrosion activities. Rust
Grip® will seal out any contact with moisture and air or chemical
pollutants that breed corrosion activity.
metal before over-coating.
Protect floors to prevent wear and damage.
Anti-slip coating when combined with aggregates, for use around high
Protection from acid splash or pooling. It will not allow acids to
penetrate to affect the surface.
Encapsulate and seal lead-based paints, asbestos, or other hazardous
RustGrip® can be applied by non-professionals, SC2 Trading recommends
using a certified applicator. To get more information, please contact us
Surface must be clean and completely dry, with no loose debris or
particles, dirt, oil, films or residues of any kind. RustGrip® will
cover rust and other coatings if they are fully adhered to the
MECHANICALLY very well, as the metallics tend to settle out.
Airless or pot sprayed: tip size .018-.020. Non-rusted steel: apply
in one coat using crosshatch method. Rusted steel: apply in two
coats using crosshatch method. For other surfaces apply in two