Benefits

• Permanently purge out residues in concrete.

• Penetrates to the interior side of the concrete and does not product a visible film.

• Seals up concrete for strong protection.

• Easy to use and clean up.

• Environmentally friendly – water-based

Uses

• Solves the damaging problems caused by water, acid, oil or juice penetration, as well as problems resulting from dusting, algae formation, soft concrete, saponification (causes vinyl tiles, paint, polyurethane and epoxy coatings to peel off), or simple concrete deterioration.

• To penetrate inside of a deteriorating concrete surface to strengthen the surface and seal the pores, thereby helping stop the surface from further deterioration.

• To clean soiled concrete and protect from further penetration.

Application

Although Inner Seal® can be applied by non-professionals, SC2 Trading recommends using a certified applicator. To get more information, please contact us at info@sc2trading.com

Preparation

• Clean surface down to bare concrete, taking care to remove all oil, dirt, dust, debris, or any other contaminants. Rinse surface well with water.

• Let concrete dry completely.

Application methods

• Can be airless or paint pot sprayed, brushed, rolled, or hand poured. Spread over the surface evenly with a squeegee.

Directions

New concrete

• Apply at 2.45m2/liter

• Let sit for 4 hours to dry.

• Apply second coat at 2.45m2/liter

• Let set for 2 days and let seep into the concrete before using the surface again. If any ponding is noticed, mop or clean to remove excess. If allowed to set on surface it will form a layer similar to glass.

Old concrete

• Apply at 2.45m2/liter

• Let set for 12 hours to soak in.

• Power wash to remove accumulated residues.

• Allow concrete to dry. If any ponding of Inner Seal® is noticed, mop or clean to remove excess. If allowed to set on surface it will cure to a glass-like finish.

• Repeat coating and washing 2 additional times.

• If large amounts of residues are still lifting from concrete, repeat a fourth time.

• Wash surface once per day until purging is complete. May take up to 7 days.

Temperature

• Freezing: 0°C (32°F).

• Boiling: 110°C (230°F). No damage if frozen.

Limitations

• Cannot be applied over wet surfaces or when water is penetrating through the surface.

• It is water-based and the surface must be dry for it to dry properly.

• It does not fill and seal cracks. It works on the interior side of the surface.

• Can only be used with concrete surfaces, as the emulsion process requires lime to activate.

< Back