-
Components easily mixed 1:1 by volume.
-
Fast curing.
-
Thick, bubble-free,
membrane possible.
-
Being a two-component product means that the quantities not mixed can be stored for later use.
-
Its low modulus gives it excellent substrate crack-bridging properties.
-
Excellent adhesion on almost any surface, with or without the use of
special primers.
-
No thinning is required but xylene may be used.
-
Excellent thermal resistance, the product never turns soft.
-
Max service temperature 80 °C,
-
Max
shock temperature 200 °C.
-
Resistance in the cold: the film remains elastic even down to -40°C.
-
Excellent mechanical high
elongation, tensile and tear strength, high abrasion resistance.
-
Good chemical resistance.
-
UV resistant.
Water vapor transmission: The
membrane breathes so there is no accumulation of humidity under the
coat. Can also be used as a joint sealant.
Clean
the
surface
using
jet water,
if
possible.
Remove
oil,
grease
and wax
contaminants.
Cement
laitance,
loose
particles,
mould
release
agents,
flaking
coatings
must
also
be removed.
Fill
surface
irregularities
with
the necessary
product.
Priming:
apply
the
required
primer
following
the guidelines
above.
Mixing:
use
a
low
speed
(300
rpm)
mixer.
Add
xylene,
5-10%
for
application
by
spraying.
Mixing
Mix
equal
volumes
(1:1)
of the
two components
manually
or with
a
low
speed
(300
rpm)
mixer.
Apply
mixed
quantities
immediately.
Pot
life
(of
mixed
quantities):
30-45
min
at 20°C.
Application
Apply
the
material
with
brush,
roller
or
spatula.
Can
be
charged
easily
with
inorganic
dry
fillers
e.g.
silica
sand.
