Excellent adhesion to almost any type of surface, with or without the use of special primers.

No thinning is required but xylene may be used.

Excellent weather resistance

Excellent thermal resistance, the product never turns soft.

Max service temperature 80°C

Max shock temperature 200 °C

Resistance to cold: the film remains elastic down to -40 °C

Excellent mechanical properties, high tensile and tear strength, high abrasion resistance.

Good chemical resistance.

Non-toxic after full cure.

Water vapor transmission: the film breathes so there is no accumulation of humidity under the coat.

Special primers available for almost any substrate.

Special additive, like ACCELERATOR, is available.

Clean the surface using jet water, if possible.

Remove oil, grease and wax contaminants.

Cement laitance, loose particles, mould release agents, flaking coatings must also be removed.

Fill surface irregularities with the necessary product.

Priming: apply the required AQUA PRIMER following the guidelines above.

Mixing: use a low speed (300 rpm) mixer. Add xylene 5-10% for application by spraying.

Apply with roller or brush in two layers.

Do not leave more than 48 hours between coats.

If more time passes (more than 4 days) or if you are unsure of the interlayer adhesion, use xylene or MEK 5-10% for application by spraying.